If it's in the SM, I'm just missing it.

What is the torque spec for the magneto flywheel on a 73 DT-3?

Thank you

Took me all night to find this haha. This is snipped out of a DT250-400 manual on the site here under service manuals. Nut & torque setting will be the same for your DT3. Thought i'd find it easy at home but none of my manuals that are a close match for model like DT1 or DT2 etc show what you're asking [shows how to undo it lol but not tightening torque]. I just do them up Damn Tight, but that's not helping you. So--being too smart for my own good i played around & think i've learnt how to snip a part page from a manual online. Here goes.
 

I see the first pic from the manual; he's holding the tool by hand while torquing the nut. I recon its got to sit solid like my second pic where i have it resting on the footrest. Only way to go. Just my ideas.,

Thank you. This helps a bunch.