Hi and Low beams toast and config way different that my 360 for which I have a spare. 

see pictures - the bulb that’s larger than the hole comes lose when I bend the 6 tangs so it cannot be removed so I am assuming this isn’t serviceable? 

any suggestions how I could pop a new bulb into this?  Or any other ideas?

thanks
martin

Hi and Low beams toast and config way different that my 360 for which I have a spare. 

see pictures - the bulb that’s larger than the hole comes lose when I bend the 6 tangs so it cannot be removed so I am assuming this isn’t serviceable? 

any suggestions how I could pop a new bulb into this?  Or any other ideas?

thanks
martin

  

That is a sealed beam. There are vendors making these today.

This is what was on some of the Enduros back in the day. It enabled the bulb to be replaced.





Here is a repop.


 

thank you
 

I walked through a process to install a replacement bulb in the original lens on this thread:

www.yamaha-enduros.com/index.php/forums/...requires-work#113216

To this day, it works just fine. This was installed on an orig DT1E lens, FYI.

Apex - thank you. I literally just ordered same bulb to stuff into old sealed beam minus busted out old bulb 

once I get this and magneto sorted it’s time to ride!

thsnk you