Hey all, when I was installing my 12 volt system on my 76 DT400 I somehow knocked this clip, picture below, off and can't quite figure out where it goes, I know it's for holding the throttle cable. If anyone could please post a picture for me it would be greatly appreciated! Thank you, Tony

On a DT 360 it slips over the circled area in the pic below. Imagine it's the same on your bike.

+1

And here's a photo with it fitted that I downloaded for my own reference.

Thank you both! Now that I see the picture it makes sense and can see how I knocked it off too! Thanks again, was a big help... Tony

For the experts, here, when did that little number start appearing on the Enduros, and what bikes should have it? I've never seen one. :

I don't know for sure but my guess is 1974... Yamaha finally got tired of people routing the throttle cable over the tank mount instead of under it is my guess.

+1

It's a 438.... part number and looking at what (poor) info is available on Partzilla and CMSNL, it was only used on the DT250/360/400s from 1974, 1975 and 1976.