×
Pictures Posting Not Working (12 Jun 2023)
Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.
Makotosun
RT2 360 Engine Re-assembly
- quidger
- Topic Author
- Offline
- Senior Member
- Posts: 38
- Likes received: 7
Replied by quidger on topic RT2 360 Engine Re-assembly
Got it! Will get it on YouTube.
26 Oct 2023 15:07
#11
Please Log in or Create an account to join the conversation.
- quidger
- Topic Author
- Offline
- Senior Member
- Posts: 38
- Likes received: 7
Replied by quidger on topic RT2 360 Engine Re-assembly
26 Oct 2023 16:46
#12
Please Log in or Create an account to join the conversation.
- MarkT
- Online
- Site Supporter
- Posts: 13529
- Likes received: 9372
Replied by MarkT on topic RT2 360 Engine Re-assembly
Might be normal. Try spinning the clutch input shaft as you try shifting up and down. They don't like to shift unless spinning.
1963 YG1-T, 1965 MG1-T, Allstate 250, 1970 CT1b, 1971 R5, 1973 AT3MX, 1974 TS400L, 1975 RD350, 1976 DT175C, 1976 Husqvarna 250CR, 1981 DT175G, 1988 DT50, 1990 "Super" DT50, 1991 RT180, 2017 XT250
The following user(s) Liked this Post: Ht1kid, msavitt
26 Oct 2023 16:59
#13
Please Log in or Create an account to join the conversation.
- RT325
- Offline
- Platinum Member
- Posts: 9753
- Likes received: 3989
Replied by RT325 on topic RT2 360 Engine Re-assembly
I'm guessing you're in neutral so you'll have a long movement up & down like you show because when it bumps into the pin at the end of the long movement it only needs to move the drum a little bit to fall into first or second depending which way ya going.
Plus what Mark said, turn one shaft. Only need a little to line up the dogs, but a spin will work for sure.
Plus what Mark said, turn one shaft. Only need a little to line up the dogs, but a spin will work for sure.
The following user(s) Liked this Post: MarkT
Please Log in or Create an account to join the conversation.
- quidger
- Topic Author
- Offline
- Senior Member
- Posts: 38
- Likes received: 7
Replied by quidger on topic RT2 360 Engine Re-assembly
Thanks, guys.
I’ll give it a spin.
I’ll give it a spin.
27 Oct 2023 05:28
#15
Please Log in or Create an account to join the conversation.
Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart