facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

AT2

  • RobertE
  • RobertE's Avatar Topic Author
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 11
  • Likes received: 13

AT2 was created by RobertE

Does anyone know what the piston to cylinder clearance should be on a fresh bore for a 72 AT2??   The AT1 shows .0016-.0018, but the AT2 has a reed s;ystem and the piston is different. Would the specs be the same?
13 Oct 2021 16:58 #1

Please Log in or Create an account to join the conversation.

  • RobertE
  • RobertE's Avatar Topic Author
  • Offline
  • Junior Member
  • Junior Member
  • Posts: 11
  • Likes received: 13

Replied by RobertE on topic AT2

Whoops, finally found the tech manual for the 72. .0016-.0018 is correct for the AT2.  
The following user(s) Liked this Post: MarkT
13 Oct 2021 17:19 #2

Please Log in or Create an account to join the conversation.

  • Posts: 9639
  • Likes received: 3915

Replied by RT325 on topic AT2

My book says "in mm" .040--.045mm which is the same as what you have in inches. My book says same for AT2 & AT3 etc. Think you measure it just above the windows as starts to taper if you go higher up, but measurement at the skirt base & 'there' should be the same. 18mm up comes to mind but that might've been YZ's with the cutaway skirt.
13 Oct 2021 17:28 #3

Please Log in or Create an account to join the conversation.

Moderators: yamadminMakotosunDEETVinnieJames Hart