×
Pictures Posting Not Working (12 Jun 2023)
Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.
Makotosun
AT1 & CT1 engine mount plates bolts question
- Gr8uncleal
- Topic Author
- Online
- Site Supporter
- Posts: 4010
- Likes received: 1951
AT1 & CT1 engine mount plates bolts question was created by Gr8uncleal
Would anyone know if the four original M8 x 16 mounting bolts for the engine mount brackets were originally partially domed (like the air box mount bolts were)?
Thanks.
Thanks.
26 Dec 2021 10:18
#1
Please Log in or Create an account to join the conversation.
- Capt.Dave
- Offline
- Platinum Member
- Posts: 577
- Likes received: 438
Replied by Capt.Dave on topic AT1 & CT1 engine mount plates bolts question
Yes.
The following user(s) Liked this Post: Gr8uncleal
26 Dec 2021 10:49
#2
Please Log in or Create an account to join the conversation.
- Gr8uncleal
- Topic Author
- Online
- Site Supporter
- Posts: 4010
- Likes received: 1951
Replied by Gr8uncleal on topic AT1 & CT1 engine mount plates bolts question
Thanks Capt Dave, much appreciated.
26 Dec 2021 10:51
#3
Please Log in or Create an account to join the conversation.
- MarkT
- Offline
- Site Supporter
- Posts: 13470
- Likes received: 9329
Replied by MarkT on topic AT1 & CT1 engine mount plates bolts question
1970 CT1 feel kind of "domed" with a small dimple in center.
1963 YG1-T, 1965 MG1-T, Allstate 250, 1970 CT1b, 1971 R5, 1973 AT3MX, 1974 TS400L, 1975 RD350, 1976 DT175C, 1976 Husqvarna 250CR, 1981 DT175G, 1988 DT50, 1990 "Super" DT50, 1991 RT180, 2017 XT250
The following user(s) Liked this Post: Gr8uncleal
26 Dec 2021 11:22
#4
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
- Gr8uncleal
- Topic Author
- Online
- Site Supporter
- Posts: 4010
- Likes received: 1951
Replied by Gr8uncleal on topic AT1 & CT1 engine mount plates bolts question
Thanks Mark.
Yes, that's what I've been trying to id look like.
Yes, that's what I've been trying to id look like.
26 Dec 2021 13:02
#5
Please Log in or Create an account to join the conversation.
Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart