facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

DT1 Crank Seals

  • RT325
  • RT325's Avatar Topic Author
  • Offline
  • Platinum Member
  • Platinum Member
  • Posts: 10828
  • Likes received: 4695

DT1 Crank Seals was created by RT325

Bought these for my 250 & 360. I know you guys say give them a swerve but i'll let you know if not worth a nob of goat crap. My 250 DT1 being a bitch but i'll try fresh fuel first. Think i put some fresh on the old lot but hates cold starts then runs perfect when warmed up & can stop & restart ok.. But leave it for a few hours & it's a lean starter then almost straight away comes good.Choke acts like the choke jet is too small But prodded it with a welding tip cleaner & did go one size larger than initial prod so 'was' restricted with old fuel. Carb was a bit of a mess & fuel cock was plugged with a glue like substance. I took some pics just have to find them. It's a 32mm 360 carb but been on there 30 or more years so something odd's going on & although i tend of think seals last indefinitely--because i've almost never had a faulty one--but have had them blow right out, but not faulty when in place. But might have to eat my words. I did find a left side new seal in the shed but not the right side. Anyway--we wait.
02 Aug 2020 03:48 #1

Please Log in or Create an account to join the conversation.

Moderators: yamadminMakotosunDEETVinnieJames Hart