Somewhere I acquired a really nice cable routing diagram for a 1974 DT250 I've been working on What I was wondering is if anything like that exists for the DT2/3 bikes.

Same here hanover.jack, but in my the case the bikes are a DT360 and RT2.

Until such time as a cable routing diagram surfaces for the RT2/3 or DT2/3 (I would imagine the one diagram would apply to all those models, if it exists at all), what I am doing is collecting as many photos as I can which show wiring and cabling in them. Useful sources are this forum (obviously!), the various manuals (owners', service etc) shown in the tech library in this forum and the internet in general. Hopefully I should be able to piece together the correct route of each and every cable and wire.

I see this goes back to 2018, did anyone ever come up with some routing pictures for the DT3?

I took a boat load of pictures of my DT2 as I tore it down. I bought bit from the original owner, and as best I can tell he'd not monkeyed around with the bike. Let me know where you'd like pictures of.

I'd like some pictures to check my DT2 for proper routing.  This email address is being protected from spambots. You need JavaScript enabled to view it. Thank you!

 

 

  



 

 

If you need any other pics let me know of the location.

Thanks BRZN!  My DT2 had that same foam under the tank, I left it off thinking that it was someone's attempt at cheap padding for whatever reason, I don't see how two people could come up with the same strange idea so I guess I should put it back on

I'm thinking your throttle cable is on upside down, if I'm not mistaken that hole in the top is for drainage.

I thought the same about the foam with my RT2… Gr8Al cleared me right up… I even used red tape… well, close enough fer me..
Sneezles61