Looking to replace my handlebars on my DT2, haven't had much luck finding any, is there a good source for them?  Thanks!

I have found a set that is close to the original ones, I will try and post some photos. 

What part off the world are you from ?

Central Florida on the east coast.  I had bout a set from an ebayer for my DT400 but he's currently out, or maybe he just has that status since he's on vacation, at any rate I'm on the hunt for them to put on my DT2 to get rid of the bent/pitted old ones.  Thanks for the reply!

What city in FLA?

I bought two of these from the Vintage Spoke : www.thevintagespoke.com/shop/XT500/Handl...0-7-019-x4523427.htm

 

They have nice chrome and are almost identical bend to the bars on my 76 DT400, but about 2 inches wider.  Nothing a hacksaw and some elbow grease can't cure.

The knurling is a little bit wider and will show on the outside of the bar clamps some.  I have not installed one yet so I don't know if they are too wide and will slip.

My two DT1 projects definitely didn't have stock bars, so I can't compare.

They don't pull back as steeply as my 75 DT100 or 75 DT175, but look to be about the same rise.

I bought these for my Ct1c about an
inch longer on each side I think they are really good
  

Lots of folks use the Fly Alumasteel "vintage bend".  They used to be cheap.  Not sure about now.  Nothing is anymore. 

I think the fly "vintage bend" changed over the last few years. First set I got was pretty close to OEM, got a set this year and they were more like cruiser bars with a lot of sweep. They said they were the same after asking, but that's not what I saw, they are still hanging on the wall.

Titusville

Thank you guys for all the suggestions, I don't know why I can't find them.  I do duckduck searches, ebay searches and come up with pretty much nothing but unrelated handlebars.