facebook1 youtube1 twitter1 instagram linkedin1 pinterest1

NOTICE:  If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community! REGISTER AND MAKE THIS BOX DISAPPEAR!

×

Pictures Posting Not Working (12 Jun 2023)

Picture uploads is again unavailable. We are working on the problem. Thanks for your patience.

Makotosun

Torque Specs

  • mplkrl@comcast.net
  • mplkrl@comcast.net's Avatar Topic Author
  • Offline
  • New Member
  • New Member
  • Posts: 1
  • Likes received: 0

Torque Specs was created by mplkrl@comcast.net

Just replaced right crank seal in 1971 125 AT1-C Enduro. Are there specific torque specs. for either the primary drive gear nut or the clutch basket nut?,,,other than the generic table in the Service Manual?
26 Mar 2021 09:21 #1

Please Log in or Create an account to join the conversation.

  • Posts: 1058
  • Likes received: 668

Replied by shyted on topic Torque Specs

Know what you mean This email address is being protected from spambots. You need JavaScript enabled to view it..
It's a fine pitch thread and pulls easy.
I put mine at 50Nm with red loctite on .
26 Mar 2021 14:52 #2

Please Log in or Create an account to join the conversation.

  • Posts: 14509
  • Likes received: 10726

Replied by MarkT on topic Torque Specs

5.8 to 7 kg-m

57 to 68 N-m

42 to 50 ft-lb
 
1963 YG1-T, 1965 MG1-T, Allstate 250, 1970 CT1b, 1971 R5, 1973 AT3MX, 1974 TS400L, 1975 RD350, 1976 DT175C, 1976 Husqvarna 250CR, 1981 DT175G, 1988 DT50, 1990 "Super" DT50, 1991 RT180, 2017 XT250
28 Mar 2021 09:23 #3

Please Log in or Create an account to join the conversation.

Moderators: yamadmin, Makotosun, DEET, Vinnie, James Hart