NOTICE: If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community!
I could use some advice on DT2 Torque settings. I do have a Clymer manual...but some of the info needed is missing:
1. 19mm Mag flywheel nut: manual says 28 ft lbs...that seems low to me
2. 29 mm nut on rh (primary gear) end of crank
3. 29 mm nut on clutch inner hub.
Also...manual says length of clutch springs is 36mm, replace if 35mm or less. Mine are ~ 34mm...but all are same length and they do not appear weak...any advice?