NOTICE: If you are not a free registered member of the site, you will not see the photos in the forum, and you won't be able to access our premium member content. Please consider joining our community!
Anyone out there know where I might get a Fork Brace for my 70 DT1c? Forks very flimsy takes very little wiggling to get forks out of alignment, is that normal? I don't remember them being this bad, but they had the braces
Just make sure the axle is tight & the clamp is pinching up the other end. then can only make sure the fork yoke clamps are tight & shouldn't be too bad. Front guard is a little help but not a lot. You're talking the steel lower sliders?, think they went alloy the following year. Used to be after market braces on ebay once upon a time.
Here's one for an AT1 but says 70--72 except 70 is steel sliders & 72 should be alloy so maybe it brackets on the same. Anyway--be too narrow for yours plus AT1 is !8 front--so forget that but take the pic to an engineer to get an idea maybe.